Week 3

This week was a very tough one.On the first day of the week ,i met my senior Mr Jega aka jack. He just arrived from Bangladesh after going there to solve a few technical problems with our customer Dhaka tobacco. He pushed me with my work,he said moving to slow and i needed to be fast. Read drawing faster and start assembly as soon as i got the parts. The problem was , as time went the units became more larger and complicated but i realized there is proper to way to fix the parts,this is a skill will i needed to develop in my self. The first day i fixed the guard or the housing for cutter knifes. Its was not easy to fix the guard unit on the Max body because i had to make sure that it could be pulled off easily from the body for the cleaning of the knifes. So it shouldn't`t be fixed too tight or too loose. Had to make sure the setting was correct.The next day,i was working on fixing the feed rollers, this is used to pull the tipping,so there will be a tension of the paper to push it to the cutting unit. By the way the feed roller is called a "MV" because it is non-fomat unit so is be pre-assembled in another section. That section is called the MV. The next day, i fixed the tipping patch extraction on the body,which is attached together with the guard. This unit is responsible for sucking all the unwanted dust and rejected tipping paper into a rubbish bin. Later that week, i assembled the motor ,v-belt and pulleys for the final cut knife unit. This motor runs the knife that cuts the double cigaratte filter rod by half.